The Right Way to Remove and Disassemble Locks from the Inside

There are numerous reasons why removing and disassembling the locks become imperative. Sometimes losing the additional key might be the reason, and some plan to remove and disassemble the lock due to a recent burglary. Whatever the reason, you must always follow the right technique to do this, or if unsure, you may call an expert.

This write-up will explain how to remove and disassemble the locks from the inside and what tools are crucial.

Tools Needed to Remove and Disassemble the Locks

Here are some common locksmith tools to remove and disassemble the lock.

• flat and cross-shaped screwdrivers
• hammer
• nail
• metal object with a sharp tip

If you also plan to create a duplicate of the key, then it is important to know what are key codes. It is necessary to convert the key code to display the lock’s bitting and demonstrate how the key should be cut.

How to Remove and Disassemble Locks

You can start by removing the handles using a nail or hammer. In some locks, you might be required to unscrew the covers using screwdrivers. Once the screws are removed, you can use the flat end of the screwdriver and pull the mechanism out of the lock. Make sure to do this with minimum pressure since higher force might damage the door, and lock replacement would become difficult.

Once you pull out the mechanism successfully, you need to find a place to disassemble it. A writing desk or a kitchen table will be ideal for this. You will also need a piece of cloth for this.

Now fold the fabric on a surface that is both level and smooth, then set the machine on top of the cloth with the fastening screws facing upward.

Next, you can turn off the screws using a flathead screwdriver. When it is removed, the complete lock mechanism is exposed for inspection. You can pull out the spring in the lock while careful that it doesn’t fly out of its seat since it is still powered.

The final step is to disengage the levers from the bolt and then pull them away from the bolt.

Points to Remember

Certain aspects would need your special attention when removing and disassembling the locks.

• You may either remove the spring by hand or pry it out with a screwdriver while protecting the mechanism behind it with a towel or your palm.
• Before assembly, it is very important to lubricate all parts of the lock mechanism, including the springs, with a special lubricant.
• It is important to wipe all parts of the mechanism with a dry clean cloth to remove old grease and assess the degree of wear and the possibility of further use or the need for replacement.

Final Thoughts

When you move into a new location, have a break-in or get a new roommate, you may need to remove and disassemble the existing locks. Most people make it seem much more difficult than it is, and the procedure may be finished in a matter of minutes rather than hours. If you follow the steps in this write-up, you should be done in no time.