Why Can’t I Access The Default IP Address Of My Netgear Router?
If you aren’t able to access the Netgear router IP of your WiFi device, then it looks like that you are in some serious trouble. The reason being, whether you want to set up your Netgear router or simply change it’s password, none of it is possible if you don’t access its web user interface. But, don’t worry, because we’ve got your back.
Through this article, we’ll help you in troubleshooting the issue in the twinkling of the eye. So, without wasting any more time, let’s get on with it, shall we?
Troubleshooting Can’t Access Router’s Default IP Address Issue
- Check the Cable Connections
Are you sure that your Netgear WiFi router is receiving an adequate power supply from the electric source? If not, then ensure that you are. To do that, here are the things that you need to consider:
- Make sure that the power socket you’re using in good condition.
- In case the power socket is damaged, then replace it with a new one immediately.
- The power cable that you’re using shouldn’t have any cuts.
If none of these tips work in your favor, then it is recommended that you power-cycle your router.
- Use the Default Web Address
Sometimes, the reason why you aren’t able to access the web user interface of your router might be because of a technical glitch. To troubleshoot this issue, make use of the default web address of your device instead of 192.168.1.1. All you have to do is:
- Open a web browser on your computer.
- Go to the address bar and enter routerlogin.net.
- Click on the Enter button to proceed further.
This way, you’ll be able to access the web user interface of your router by using the web address.
- Make Use of the Correct IP Address
Let’s say that you’ve entered the right web address and have been very careful while doing so, but still aren’t able to access the IP address of your router, then? A little frustrating, isn’t it? Perhaps you’re using the wrong IP address to access the web user interface of your WiFi router.
Thus, make sure that you cross-check the IP address before using it to log into your router. On the off chance, if you aren’t able to resolve the issue, then use 10.0.0.1 to access the interface of your WiFi device.
- Update the Firmware of the Router
Another blunder that you might have made while trying to log into your router is that you haven’t updated the firmware of your WiFi device. Updating a device that you’re using is pretty damn important if you want it to work properly.
Here are the steps that you need to consider in order to update the firmware of your device:
- Install an internet browser on your system.
- Access the web user interface of your Netgear router.
- Navigate to the Settings option.
- Then, go to Administration and update the firmware of your WiFi device.
Still stuck with the can’t access the router IP issue? Hmm. In that case, it is recommended that you giving factory default reset a try.
Scroll down and continue reading to know how to restore your Netgear WiFi router to its factory default settings.
- Perform Factory Default Reset
- Look for the Reset button at the bottom of your WiFi router.
- Once located, press it with the utmost care.
- Use a sharp pin-like object to press the button.
Once you’re done restoring your device to its factory default settings, try to access the default IP address. This time you surely will be able to.
Read A2 Hosting Review
