Follow These Tips and Tricks to Clean your Water Tank

What Are The Various Uses Of A Water Tank?

A water tank, as the name suggests, is used for storing water. This water stored is used for different purposes such as drinking water, household purposes, agricultural irrigation, fire suppression, different kinds of chemical productions, etc. Water tanks are made out of many other materials like plastic, concrete, stone, steel, fibreglass, and even earthen pots.

How to Clean Your Water Tank?

Since the water stored in the tank is used for essential purposes, the tank must be clean to maintain water quality. The water inside the tank should be clean and free of bacteria. If not cleaned regularly, the water tanks will get covered in algae, silt, and other bacteria and microorganisms, which will hamper water purity and ultimately affect its quality. Cleaning a tank is tiresome, but it is just as essential. It includes a couple of simple steps, such as draining the tank, cleaning the interior walls, and finally sterilizing the tank. Let us have a look at them, step-by-step-

Draining The Tank

A series of steps must be followed to drain the water tank properly. This will empty all the water from it and make it ready for cleaning. You must open the outlet valve or the tap at the bottom for draining the tank. Next, a hose should be connected to release the water in the tank into a place where it will not cause any flooding and be safely utilized.

For permanent water tanks, there is a washout valve located at the base of the valve. The remaining water at the bottom of the tank must be scooped out of it with a bucket to be completely drained and ready to be cleaned. For the rest of the water, a wet vacuum and towel can be used.

Cleaning And Sterilizing The Tank

Mix hot water and laundry detergent to clean the tank. Use an abrasive sponge or a bristle brush to scrub the inside of the tank with the detergent and water mixture. Repeat this process until most of the slime and sludge from the tank is removed. Use an appropriate brush with the right handle length, depending on the size of your tank. Brushes with steel bristles or similar steel sponges must be avoided because they can scratch the inside of the tank and damage it.

For particularly the dirty walls of your tank, baking soda can be used. You can sprinkle a little baking soda on them and then scrub them with a brush to clean the dirt. Make sure you clean all the corners and joints of the tank thoroughly. You can use a small brush to reach these areas.

After the scrubbing process is done, the water tank needs to be rinsed thoroughly. You can use a hose to spray on the walls of the tank to rinse them. Remember to rinse the entire tank properly, all the nooks and corners as well. Another method of rinsing the tank is by filling it with hot water and letting it soak from the inside for a couple of hours. Drain this water and then repeat the process until the inside of the tank is entirely free of detergent. The remaining detergent water at the bottom can be removed using a vacuum.

After this rinsing process is done, you can use a rag or a mop to remove the water from corners that still might have water or sediment left in them. Next, clean the pipes and hoses of the tank using the same cleaning solution and then pumping water through them.

The next step is to disinfect the tank. This can be done by filling three-quarters of the tank with water and then adding bleach in the ratio of 50 ppm. Then fill the rest of the tank and leave it for 24 hours. Then again, drain the tank completely. It is advisable to contact the water tank supplierfor any extra precautions you might have to take.

Cleaning your tank might seem like a daunting task at first; however, like several other things, as you get into it, following all rules and precautions of cleaning, it doesn’t seem like a very tough project anymore.